AEM 5 bar MAP sensor mässing Visa större

AEM 5 bar MAP sensor mässing

Nyhet

AEM 5 bar MAP sensor.

För laddtryck upp till 4 bar och ner till fullt vakuum.

Gänga: 1/8" NPT.

Material: Mässing.

Levereras komplett med kontaktstycke.

Se mer information nedan och bifogad PDF Manual/Datablad.

 

Mer detaljer

Lägg till i min önskelista

Mer information

30-2131-75 - 75 PSIa or 5 Bar Brass Sensor Kit

  • Accuracy: +/- 3% Full Scale over -40C to 105C includes Repeatability, Hysteresis and Linearity
  • Operating Temp: -40C to 105C / -40F to 221F
  • Burst Pressure: 150PSI
  • Response Time: < 1ms
  • Vibration:100 to 2000Hz, 20g Sinusoidal, 3 Axes
  • Sensor Body: Brass
  • Wetted Materials: 304L & 316L Stainless Steel
  • Thread: 1/8" NPT Male Thread
  • Weight: < 85 Grams
  • Supply Current: 
  • Output: .5 to 4.5Vdc Linear
  • Elec. Termination: Integral weatherproof connector, includes mating connector, pins & pin lock
  • Includes: 75 PSIa or 5 Bar Brass Sensor, Connector, Pins & Pin Lock

Absolute (PSIa) Pressure Sensors
AEM offers high quality stainless steel PSIa sensors in 15 (1BAR), 30 (2BAR), 50 (3.5BAR), and 75 (5BAR). PSIa is referenced to absolute zero. Absolute zero is the pressure measurement when all the pressure exerted by the atmosphere has been removed. The most common use for absolute pressure sensors is reading manifold pressure. PSIa sensors are required if you wish to measure vacuum. A PSIa sensor will read about 14.7 PSI when the sensing element is exposed to atmospheric pressure at sea level however they can be recalibrated to read zero at atmospheric and a negative number at values less than atmospheric pressure.

Which Pressure Sensor is right for you?

There are many different tools that can be used for measurement, but the degree of accuracy is dependent upon the tool. For example, a ruler can measure distance with a good degree of accuracy, but for a more precise measurement a caliper should be used. The difference between a brass pressure sensor and a stainless steel pressure sensor is similar if we think about it in these terms:

Brass Pressure Sensor = Ruler
Use a Brass Pressure Sensor where you need a good reference to what pressure is being seen.
Example: Brass Pressure Sensor used for a Boost Gauge – Reference/Information for knowing manifold pressure, not for ECU calibration.

Stainless Pressure Sensor = Caliper
Use a SS Pressure Sensor where you need exact details of the pressure.
Example: MAP Sensor information for the ECU – Calibration/crucial information for the ECU.

Omdömen

Inga kommentarer finns för tillfället.

Skriv din recension

AEM 5 bar MAP sensor mässing

AEM 5 bar MAP sensor mässing

AEM 5 bar MAP sensor.

För laddtryck upp till 4 bar och ner till fullt vakuum.

Gänga: 1/8" NPT.

Material: Mässing.

Levereras komplett med kontaktstycke.

Se mer information nedan och bifogad PDF Manual/Datablad.

 

Skriv din recension

Ladda ner